Another Piano Bench Plans
The piano bench shown is best made of black walnut or oak and should be finished in the natural color for walnut, but stained some rich brown for oak.The following pieces will be needed:
- 1 top, 1 by 15-1/2 by 38-1/2 in., S-2-S.
- 2 legs, 1 by 14-1/2 by 20-1/2 in., S-4-S.
- 2 rails, 7/8 by 3-3/4 by 36-1/2 in., S-2-S.
- 1 stretcher, 3/4 by 4-1/4 by 37 in., S-2-S.
The keys can be secured from the waste that will be cut off from the other parts.Square up the top in the usual manner to the size indicated in the working drawing. In a similar manner square up the stretcher to width and length.There will be no need to square the ends of the rails as they are to be cut off on a slant. Square up the sides or edges and then lay off and cut the slanting ends, smoothing them with the plane. Lay off and work the shape on their under edges.The ends are best laid off by means of a template or pattern for which a piece of rather heavy paper will do. Lay off the main dimensions on a center line. Sketch in the curve of the edge after the slant has been laid out. Lay out the form at the bottom, then fold the paper along the center line and trace the other half. With this pattern lay off the outline upon the wood. For convenience in laying out the grooves for the rails and the mortise for the tenon on the stretcher, it is well to work a face edge upon each leg and allow this to remain until these joints have been made and the parts fitted. The shape at the bottom of the leg is merely suggestive and may be modified as desired.Lay out and work the tenons on the stretcher. Then lay out and work the grooves upon the rails. Each side of each rail is grooved 1/8 in, to allow the leg to be recessed. This is done to give the bench the bracing that is needed to make it stand firmly. Work the grooves in the legs and the mortises for the rails.It should be noted that the mortise for the key in the stretcher must be laid out before the shoulders and cheeks of the tenon on which the mortise is made are cut off. Otherwise there would be no place to put the gauge in marking the sides of the mortise for the key.Thoroughly scrape all the parts and then assemble them. No glue is needed. The rails are held in place by dowel pins, the heads of which are allowed to project slightly and rounded so as to give an ornamental effect. The top is attached by means of small angle irons or by means of blocks and screws fastened to the corners made by top and rails.
These are free old vintage plans that were scanned or taken from old magazines for you to use and not to be confused with plans I sell on this site that I have drawn myself a short while back.
My Woodworking Plans and CD'sPlease take a look at my "woodworking/construction plans" and/or my old books on CD / DVD on this site by clicking "Do It Yourself Plans" in the black menu bar above on the very Left? You will most likely find something that is very interesting or useful to you?